Enable Engineering Home Page     
ARM Evaluation Board
 
ARM Evaluation Board

Philips/NXP ARM7TDMI Evaluation Board LPC3180

Philips/NXP ARM7TDMI Evaluation Board LPC3180    $20.00
Philips/NXP ARM7TDMI processor with 8 kB cache, operating at up to 60 MHz Evuluation Board
  • Includes a CD with a user manual, full schematics, and sample software.
  • - Power Source Options are just one AA battery, USB, or external 5V DC.
  • - 20 Way JTAG connector.
  • - 16M (8M x 16) Bytes of SDRAM.
  • - 8M (4M x 16) Bytes of FLASH. - Expandable to 16M (8M x 16) Bytes of FLASH.
  • - 1 x LCD Module with Epson S1D15605 built in. - 1 x SD Card connector.
  • - 1 x USB connector (USB B Receptacle Connector for USB Device).
  • - 1 x UART (RS232) physical interface circuits connected to standard PC style DB9 male connector.
  • - 1 x Headphone jack (3.5mm).
  • - Site for an additional headphone jack (3.5mm).
  • - 2 x 10, 2 x 20 pin break-out headers.
  • - Reset pushbutton switch.
  • - Mode Selection pushbutton switches.
  • - Start, Stop pushbutton switches.
  • - 1 x User output LED.
  • 3 x Power Supply Status LEDs.
  • - Prototyping area
  • - FLASH MassDFU programming utility
  • - Many Philips and 3rd party software examples
  • - ARM7TDMI processor with 8 kB cache, operating at up to 60 MHz
  • - 1 MB on-chip flash program memory with 128-bit access for high performance
  • - 64 kB SRAM
  • Boot ROM allows execution of flash code, external code, or flash programming via USB
  • - On-chip DC-to-DC converter can generate all required voltages from a single battery or from USB power
  • - Multiple internal buses allow simultaneous simple DMA, USB DMA, and program execution from on-chip flash without contention
  • - External memory controller supports flash, SRAM, ROM, and SDRAM
  • - Advanced Vectored Interrupt Controller, supporting up to 30 vectored interrupts
  • - Innovative Event Router allows interrupt, power-up, and clock-start capabilities from up to 107 sources
  • - Multi-channel GP DMA controller that can be used with most on-chip peripherals as well as for memory-to-memory transfers
  • - Serial interfaces:
    • - Hi-Speed USB 2.0 device (480 Mbit/s or 12 Mbit/s) with on-chip physical layer
    • - UART with fractional baud rate generation, flow control, IrDA support, and FIFOs
    • - I2C-bus interface,/UL>
    • - I2 S-bus (Inter IC Sound bus) interface for independent stereo digital audio input and output
  • - SD/MMC memory card interface
  • - 16-bit stereo A/D and D/A converters with amplification and gain control
  • - Advanced clock generation and power control reduce power consumption with 32-bit timers with selectable prescalers
  • - 8-bit/4-bit LCD interface bus
  • - Watchdog Timer with interrupt and/or reset capabilities.
  • - 10-bit A/D converter with 5-channel input multiplexing
  • LPC3000 Board User Manual
 



Google
Enable Engineering Co., Inc.